ZyXEL Communications MSC1000G - Page 649

Chapter 19 acl Commands
Management Switch Card User’s Guide
649
lan2lan disable <slot-
port>
Disables LAN 2 LAN on the specified subscriber
port(s). LAN 2 LAN allows you to set whether
or not a DHCP server connected to a subscriber
port is permitted to receive and send traffic
through the IES.
8
enable <slot-
port>
Enables LAN 2 LAN on the specified subscriber
port(s).
8
show
<slot>|<slot-
port>
Displays LAN 2 LAN settings on the specified
slot or subscriber port(s).
1
pool delete <slot-
port> <ip-
address>
Removes the static IP address from the DHCP
snooping table.
8
set <slot-port>
<ip-address>
Adds a static IP address to the DHCP snooping
table. You can add up to 3 static IP addresses
per port.
8
show <slot>|<slot-
port>
Displays the DHCP snooping table on the
specified port.
1
dhcpv6relay delete <vid>
Deletes the DHCPv6 relay settings for the
specified VLAN.
8
ldra disable <vid>
Has the system not use Lightweight DHCPv6
Relay Agent (LDRA) service for the specified
VLAN.
8
ldra enable <vid>
Has the system use LDRA service for the
specified VLAN.
8
set <vid>
Creates a DHCPv6 relay entry for the specified
VLAN.
8
show [vid]
Displays the DHCPv6 relay settings for the
specified VLAN.
8
opt delete <vid>
Removes the configured DHCPv6 relay option
settings for the specified VLAN.
8
opt disable <vid> 37
Has the system not use the DHCPv6 relay
remote ID option settings for the specified
VLAN.
option-id: Option ID number (37).
8
opt enable <vid> 37
Has the system use the specified DHCPv6 relay
option settings for the specified VLAN.
8
Table 347 acl Commands (continued)
COMMAND DESCRIPTION P