ZyXEL Communications MSC1000G - Page 650

Chapter 19 acl Commands
Management Switch Card User’s Guide
650
opt set <vid> <option-
id> <format>
Sets the specified DHCPv6 relay option
information for the specified VLAN.
option-id: Option ID number (18 for interface
ID or 37 for remote ID).
format: a text string with the ‘%’ character
reserved to denote the start of a predefined
runtime variable. Here is the rule:
%%: equals character %
%0x00~0xFF: represents byte value
%pname: configured port name
%ptel: configured port tel
%pid: port index
%chvpi: channel vpi
%chvci: channel vci
%slotid: slot index of the logic port
%svlan: Service provider VLAN (SVLAN) ID
the DHCP client is on
%cvlan: Customer VLAN (CVLAN) ID the DHCP
client is on
%hname: host device name
%cmac: MAC address of client, represents as
Byte
%phtype: ATM: "atm" Ethernet: "eth"
%blank: blank character
8
dot1x disable
Turns off IEEE 802.1x authentication. 8
enable
Turns on IEEE 802.1x. 8
port control <slot-
port>
auto|auth|unauth
Sets the IEEE 802.1x port authentication option
for specific subscriber ports.
auto: authentication required
auth: forced authentication
unauth: forced no authentication
8
disable <slot-
port>
Turns off IEEE 802.1x for specific subscriber
ports.
8
enable <slot-
port>
Turns on IEEE 802.1x for specific subscriber
ports.
8
period <slot-
port> <secs>
Sets the IEEE 802.1x re-authentication period
(60~65535) for specific subscriber ports.
8
reauth <slot-
port> on|off
Enables/disables the IEEE 802.1x re-
authentication option for specific subscriber
ports.
8
show <slot>
Displays IEEE 802.1x settings for the specified
slot.
1
Table 347 acl Commands (continued)
COMMAND DESCRIPTION P