ZyXEL Communications MSC1000G - Page 651

Chapter 19 acl Commands
Management Switch Card User’s Guide
651
radius ip <index> <ip-
address>
Sets the IP address of the specified external
RADIUS server (1 or 2).
index: The RADIUS server number.
8
port <index>
<port>
Sets the external RADIUS server port number of
the specified RADIUS server.
index: The RADIUS server number.
8
secret <index>
<secret_key>
Sets the authentication and encryption key of
the specified RADIUS server.
index: The RADIUS server number.
secret_key: The authentication encryption key
(<=31 characters).
8
show
Displays the external RADIUS server settings. 1
dsbcast enable <slot-port>
<vid>
Turns on the blocking of downstream broadcast
packets from going to the specified VLAN on the
specified port.
8
disable <slot-port>
<vid>
Turns off the blocking of downstream broadcast
packets to go to the specified VLAN on the
specified port.
8
show <slot>|<slot-
port>
Displays the settings for blocking downstream
broadcast packets for the specified slot or port.
8
dscp disable <slot-port>
Stops the DSCP (Differentiated Services Code
Point) service on the specified slot and port.
DSCP is a field in the header of IP packets for
packet classification purposes. QoS (Quality-of-
Service) uses DSCP to provide different level of
services and priorities. See Section 19.9 on
page 668 for more information.
8
enable <slot-port>
Enables DSCP service on the specified slot and
port.
8
set <codepoint>
<priority>
Sets DSCP settings.
codepoint: Each number of codepoints
represents a level of service (0~63).
priority: 0~7 (0 is the lowest priority level
and 7 is the highest)
8
show [slot]
Displays global DSCP settings or for the
specified slot.
slot: is between slot 1 and 5 except the MSC
slot.
1
loopguard disable <giga-
port>|<slot-
port>
Disables loop guard on the specified port(s). 8
enable <giga-
port>|<slot-
port>
Enables loop guard on the specified port(s). The
system shuts down a port if the system detects
that packets sent out on the port loop back to
the system.
Note: The loop guard feature cannot be enabled
on ports with Spanning Tree Protocol
(RSTP or MSTP) enabled.
8
Table 347 acl Commands (continued)
COMMAND DESCRIPTION P