ZyXEL Communications MSC1000G - Acl Dhcpsnoop Flush Command

Chapter 19 acl Commands
Management Switch Card User’s Guide
662
19.6.3 acl dhcpsnoop flush Command
Syntax:
acl dhcpsnoop flush <slot-port>
This command clears the DHCP snooping binding table. The system automatically clears the binding
table when you disable DHCP snooping on a port.
19.6.4 acl dhcpsnoop lan2lan disable Command
Syntax:
acl dhcpsnoop lan2lan disable <slot-port>
This command turns off LAN 2 LAN on the specified subscriber port(s). This stops DHCP query
packets from being sent out through this port and drops DHCP offer packets received from this
port.
19.6.5 acl ldhcpsnoop lan2lan enable Command
Syntax:
acl dhcpsnoop lan2lan enable <slot-port>
This command turns on LAN 2 LAN on the specified subscriber port(s). This allows the subscriber to
allow a DHCP server connected to the specified DSL port to receive and send DHCP packets through
the IES.
19.6.6 acl dhcpsnoop lan2lan show Command
Syntax:
acl dhcpsnoop lan2lan show <slot-port>
This command displays LAN 2 LAN settings on the specified subscriber port(s).
19.6.7 acl dhcpsnoop pool set Command
Syntax:
acl dhcpsnoop pool set <slot-port> <ip-address>
This command adds a static IP address to the DHCP snooping table on a port.