ZyXEL Communications MSC1000G - Acl Dot1 X Commands

Chapter 19 acl Commands
Management Switch Card User’s Guide
665
19.8 acl dot1x Commands
Use these commands to configure the IEEE 802.1x authentication feature.
19.8.1 acl dot1x disable Command
Syntax:
acl dot1x disable
This command turns off the IEEE 802.1x authentication feature.
19.8.2 acl dot1x enable Command
Syntax:
acl dot1x enable
This command turns on the IEEE 802.1x authentication feature.
19.8.3 acl dot1x port control Command
Syntax:
acl dot1x port control <slot-port> auto|auth|unauth
where
This command sets the IEEE 802.1x port authentication option for specific subscriber ports.
19.8.4 acl dot1x port disable Command
Syntax:
acl dot1x port disable <slot-port>
This command turns off IEEE 802.1x for the specified subscriber ports.
19.8.5 acl dot1x port enable Command
Syntax:
acl dot1x port enable <slot-port>
This command turns on IEEE 802.1x for the specified subscriber ports.
auto =
Authenticate all subscribers before they can access the network through this port.
auth =
Allow all connected users to access the network through this port without
authentication.
unauth =
Deny all subscribers access to the network through this port.