Chapter 3 The Web Configurator
Management Switch Card User’s Guide
67
Static MAC
Multicast
This link takes you to a screen where you can configure MAC address-based static
multicast group entries.
MVLAN This link takes you to a screen where you can configure multicast VLAN.
Misc This link takes you to a screen where you can configure how the system handles unknown
multicast, IPv4 reserved multicast group, and IPv6 multicast traffic.
Port
ADSL This link takes you to screens where you can configure the ADSL ports.
VDSL This link takes you to screens where you can configure the VDSL ports on VLCs that follow
the VDSL MIB as defined in ADSL Extension Line MIB (RFC 3440).
VDSL2 This link takes you to screens where you can configure the VDSL2 ports on VLCs that follow
the VDSL2 MIB (defined in draft-ietf-adslmib-vdsl2-06).
SHDSL This link takes you to screens where you can configure the SHDSL ports.
PVC This link takes you to screens where you can configure PVCs (Permanent Virtual Circuits)
on subscriber ports.
Copy This link takes you to a screen where you can copy port settings from a source port to
destination ports on the same type of line card.
IP Bridge This link takes you to a screen where you can configure IP-aware bridging, where the
system forwards packets based on destination IP address instead of destination MAC
address.
G.bond This link takes you to screens where you can configure G.bond, letting subscribers connect
to an ISP using data streams spread over multiple DSL lines.
VoIP SIP This link takes you to a screen where you can configure VoIP SIP settings.
VoIP H248 This link takes you to a screen where you can configure VoIP H248 settings.
Enet This link takes you to a screen where you can configure the Fast Ethernet ports.
DTPVC This link takes you to a screen where you can configure DTPVCs (Double-Tag Permanent
Virtual Circuits) for ADSL or SHDSL subscriber ports.
E1 This link takes you to a screen where you can configure E1 ports on an IMA line card.
VDSL2 PVC This link takes you to a screen where you can configure PVCs for VDSL subscriber ports.
Default This link takes you to a screen where you can reset a port to its default settings.
PAEPVC This link takes you to a screen where you can configure PPPoA-to-PPPoE translation PVCs
for subscriber ports.
VDSL2 PAEPVC This link takes you to a screen where you can configure PPPoA-to-PPPoE translation PVCs
for VDSL subscriber ports.
IMA
Group This link takes you to a screen where you can group multiple E1 ports on an IMA line card
in order to increase the total upstream bandwidth.
PVC This link takes you to a screen where you can configure PVC for E1 ports on an IMA line
card.
DTPVC This link takes you to a screen where you can configure DTPVCs (Double-Tag Permanent
Virtual Circuits) for E1 ports on an IMA line card.
MGTPVC This link takes you to a screen where you can configure a PVC for transmitting in-band
management traffic only between the IMA line card and a remote IMA device.
Profile
ADSL This link takes you to a screen where you can configure ADSL profiles.
VDSL This link takes you to a screen where you can configure VDSL profiles.
VDSL2 This link takes you to screens where you can configure VDSL2 template profiles, line
profiles and channel profiles for the VLC1424G.
Table 3 Navigation Panel Links (continued)
LINK DESCRIPTION
To Next Page
Loading...
