ZyXEL Communications MSC1000G - Acl Rule Show Command

Chapter 19 acl Commands
Management Switch Card User’s Guide
680
where
This command allows you to apply an access control profile to the specified DSL link(s). You can
apply up to eight profiles to a subscriber port.
The following example applies the “example” rule to PVC.
19.16.4 acl rule show Command
Syntax:
acl rule show <slot-port-vpi/vci>
This command displays the current access control rule assignment settings. The following figure
shows an example.
19.17 acl usbcastctrl Commands
Use the acl usbcastctrl commands to configure maximum bandwidth settings for all upstream
traffic entering the MSC.
19.17.1 acl usbcastctrl set
Syntax:
acl usbcastctrl set <rate>
This command sets the maximum bandwidth for all upstream broadcast traffic entering the MSC.
The following figure shows an example.
<profile>
=
Name of an access control profile.
ras> acl rule set 3-1-0/33 example
ras> acl rule show 3-1-0/33
pvc profile
-------------- --------------------------------
3-1-0/33 example
ras>
ras> acl usbcastctrl enable
ras> acl usbcastctrl set 96