Management Switch Card User’s Guide 683
CHAPTER 20
alarm Commands
This chapter describes the alarm management commands.
20.1 General alarm Command Parameters
The following table describes commonly used alarm command parameter notation.
20.2 alarm Commands Summary
The following table lists the alarm commands. The P column on the right indicates the
administrator privilege level needed to use the command.
Table 348 General alarm Command Parameters
NOTATION DESCRIPTION
alarm
Specify a category of alarms.
eqpt represents equipment alarms.
dsl represents Digital Subscriber Line (DSL) alarms.
enet represents Ethernet alarms.
sys represents system alarms.
all specifies every alarm category.
severity
Specify an alarm severity level (critical, major, minor, info or all).
condition
Specify an alarm condition. condition|code|all
sdate
Specify a start date in yyyy/mm/dd format.
edate
Specify an end date in yyyy/mm/dd format.
target
snmp|syslog|all|none ‘none’ disables alarm reports on this alarm category.
for|rev
Specify the displaying order. for = forward, rev = reverse
detail
Display more comprehensive alarm condition descriptions.
fac
This is an alarm category. Options are: local1~local7
Table 349 alarm Commands
COMMAND DESCRIPTION P
alarm clear
Erases historic alarm entries. 8
cutoff
Cancels an alarm. This stops the sending of the
alarm signal current.
8
To Next Page
Loading...
