Chapter 20 alarm Commands
Management Switch Card User’s Guide
686
The following example removes the historic minor level alarms for all alarm categories, and all
conditions.
20.3.5 alarm history show Command
Syntax:
alarm history show [<severity>|all] [<alarm>|all] [<condition>|all] [<sdate>|all]
[<edate>|all] [for|rev] [detail]
This command displays historic alarms by severity, alarm category or alarm condition.
The following example displays the historic major level alarms for all alarm categories, and all
conditions.
20.3.6 alarm port set Command
Syntax:
alarm port set all|mgmt|<giga-port>|<slot-port> <severity>
where
This command sets the alarm severity threshold for recording alarms on an individual port(s). The
system reports an alarm on a port if the alarm has a severity equal to or higher than the port’s
threshold.
The following example has the systems only record critical alarms on DSL port 7 on the line card in
slot 4.
ras> alarm history clear minor
ras> alarm history show major
no alarm condition severity timestamp source
------ ------ ------------------------ -------- -------------- -------
1 eqpt +LT_INACTIVE major 09/09 09:38:54 slot 4
2 eqpt +LT_INACTIVE major 09/09 09:38:54 slot 9
3 eqpt -LT_INACTIVE major 09/09 09:39:25 slot 4
4 eqpt -LT_INACTIVE major 09/09 09:39:28 slot 9
<fac> =
The log facility (local1~local7) that has the device log the syslog messages to
different files in the syslog server. See your syslog program’s documentation for
details.
<target> =
snmp|syslog|all|none The type of alarm messages that the device is to
send (SNMP, syslog or all).
none disables alarm reports on this alarm category.
ras> alarm port set 4-7 critical
To Next Page
Loading...
