Management Switch Card User’s Guide 721
CHAPTER 25
ip Commands
Here is how to use the ip commands to configure the IP (Internet Protocol) version 4 parameters.
Note: The ip commands are for management purposes, rather than for user traffic.
25.1 ip Commands Summary
The following table lists the ip commands. The P column on the right indicates the administrator
privilege level needed to use the command.
Table 357 ip Commands
COMMAND DESCRIPTION P
ip arp flush
Clears the device’s IP Address Resolution
Protocol (ARP) table.
8
show
Displays the device’s IP ARP table. 1
gateway <ip-address>
Sets the default gateway IP address. 8
ping <ip-address>
[-l <size>] [-
n <count> |-t]
Pings a host (default 3 times)
size: 0-1472 bytes
count: number of pings.
-t: continously send pings to the destination
until you press Ctrl-C.
1
route delete <dst-ip>[/<netmask>]
<gateway-ip>
Removes a routing table entry. 8
set <dst-ip>[/<netmask>]
<gateway-ip>
[<metric>] [<name>]
Adds or modifies a route entry.
gateway-ip: a gateway IP address of
‘0.0.0.0/0’ means a default gateway.
8
show
Displays the routing table. 1
show
Displays the IP addresses of the in-band and
out-of-band management interfaces and the
default gateway, as well as the in-band
management VLAN ID.
1
To Next Page
Loading...
