ZyXEL Communications MSC1000G - Page 738

Chapter 28 multicast Commands
Management Switch Card User’s Guide
738
show <slot>|<slot-port>
Displays IGMP control message statistics
for the specified slot or port.
1
ipv6passthro
ugh
set flood|drop|disable
Sets how to handle IPv6 multicast packets.
flood: Forwards all IPv6 multicast packets
to all ports.
drop:Drops all IPv6 multicast packets.
disable: Handles IPv6 multicast packets
depending on the following settings:
• Static MAC multicast, configured using
the multicast mvlan set command.
• Unkonwn multicast, configured using
the multicast mvlan nonmemberport
commands
8
show
Displays the setting of IPv6 multicast
packet forwarding.
1
mvlan delete <vid>
Removes a multicast VLAN. 8
disable <vid>
Deactivates a multicast VLAN. 8
enable <vid>
Activates a multicast VLAN. 8
group delete <vid>
<index>
Removes a multicast VLAN group. 8
set <vid> <index>
<start-mcast-ip>
<end-mcast-ip>
Sets a multicast VLAN group. 8
name <name>
Sets the name of the multicast VLAN
setting.
8
nonmemberp
ort
<pass|discard>
Set whether to process IGMP/MLD packets
if the destined multicast group belongs to
an MVLAN, but the port which received the
IGMP/MLD packets is not a member of the
MVLAN.
pass: Forwards the IGMP/MLD packets in
the original VLAN.
discard: Drops the IGMP/MLD packets.
1
priority <vid> <priority>
Changes the 802.1p priority to the same
level as what you configured for IGMP/MLD
pakcets for the MVLAN.
8
set <vid> <slot-port>
<fix
[cvid]|forbid>
Sets the port multicast group membership
settings.
fix [cvid]: Adds the port to the specified
VLAN group.
cvid: The customer VLAN ID.
forbid: Remove the port from the
specified VLAN group.
8
show <vid> [slot]
Displays the multicast VLAN settings for all
slots or only for the specified slot.
1
Table 362 multicast Commands (continued)
COMMAND DESCRIPTION P