Chapter 28 multicast Commands
Management Switch Card User’s Guide
742
28.4.2 multicast groupmacaddr set Command
Syntax:
multicast groupmacaddr set <vid> <group-mac-addr> <giga-port>|<slot-port> fix|forbid
where
This command configures static MAC multicast to allow incoming frames based on multicast MAC
address(es) that you specify. Use this to pass allowed layer 2 multicast packets through the IES.
The following example configures VID 2 to have the multicast MAC address 01:01:5E:00:00:05 on
port 2 in slot 9 as a fixed member.
28.4.3 multicast groupmacaddr show Command
Syntax:
multicast groupmacaddr show <vid> <group-mac-addr>
This command displays the settings of a static multicast MAC address. The following example shows
the setting for VID 2 for multicast MAC address 01:01:5E:00:00:055.
28.5 multicast fastleave Commands
Use these commands to enable the multicast fastleave feature on the system. This allows the
system to immediately remove a port from a multicast group when a leave message is received and
<group-mac-addr> =
The static multicast MAC address.
ras> multicast groupmacaddr set 2 01:01:5E:00:00:05 9-2 fix
ras> multicast groupmacaddr show 2 01:01:5E:00:00:05
vid mac
---- -----------------
2 01:01:5e:00:00:05
slot port(F:fix, X:forbid)
---- ------------------------------------------------------------------------
1 2 3 4 5 6 7
123456789012345678901234567890123456789012345678901234567890123456789012
1 XXXX
2 ----
3
4 XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
5 XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
6 XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
7 XXXXXXXXXXXXXXXXXXXX
8 XXXXXXXXXXXXXXXXXXXX
9 XFXXXXXXXXXXXXXXXXXXXXXX
10 XXXXXXXXXXXXXXXXXXXXXXXX
To Next Page
Loading...
