Chapter 28 multicast Commands
Management Switch Card User’s Guide
746
The following command turns off the IGMP count limit for DSL port 4 on the line card in slot 3.
28.8.2 multicast igmpcount enable Command
Syntax:
multicast igmpcount enable <slot-port>
This command turns on the IGMP count limit for the specified DSL port(s).
The following command turns on the IGMP count limit for DSL port 4 on the line card in slot 3.
28.8.3 multicast igmpcount set Command
Syntax:
multicast igmpcount set <slot-port> <count>
This command sets the IGMP count limit for the specified DSL port(s).
The following command sets a IGMP count limit of 2 for DSL port 4 on the line card in slot 3.
28.8.4 multicast igmpcount show Command
Syntax:
multicast igmpcount show <slot>
ras> multicast igmpcount disable 3-4
ras> multicast igmpcount enable 3-4
ras> multicast igmpcount set 3-4 2
To Next Page
Loading...
