ZyXEL Communications MSC1000G - Multicast Igmpfilter Show Command

Chapter 28 multicast Commands
Management Switch Card User’s Guide
748
28.9.2 multicast igmpfilter show Command
Syntax:
multicast igmpfilter show <slot>
This command displays which IGMP filter profile DSL ports are using.
The following example displays which IGMP filter profiles the DSL ports in slot 3 are using.
28.10 multicast igmpmsgcount Commands
Use these commands to limit the number of IGMP control messages allowed to flow through the
specified slot and port.
28.10.1 multicast igmpmsgcount disable Command
Syntax:
multicast igmpmsgcount disable <slot-port>
This command disables limiting the number of IGMP control messages allowed to flow through the
specified slot and port.
28.10.2 multicast igmpmsgcount enable Command
Syntax:
multicast igmpmsgcount enable <slot-port><count>
ras> multicast igmpfilter show 3
<<slot3 igmpfilter configuration>>
port igmpfilter
---- -------------------------------
1 DEFVAL
2 DEFVAL
3 DEFVAL
4 DEFVAL
5 DEFVAL
6 DEFVAL
7 DEFVAL
8 DEFVAL
9 DEFVAL
------------------------- [snip] -------------------------
44 DEFVAL
45 DEFVAL
46 DEFVAL
47 DEFVAL
48 DEFVAL