Chapter 28 multicast Commands
Management Switch Card User’s Guide
753
This command configures a static multicast group entry.
The following example creates a static multicast group for VLAN 23. The static multicast address is
239.255.255.255 and DSL port 9 in slot 7 is a permanent member.
28.12.3 multicast smcast show Command
Syntax:
multicast smcast show
This command displays the system’s static multicast group configuration.
An example is shown next.
fix|forbid|normal =
This controls the static multicast group membership status of the port
(or ports).
fix: Sets the port to be a permanent member of the multicast group.
normal: Allows the port to join the multicast group when the device
adds it through IGMP protocol.
forbidden: Prohibits the port from joining the multicast group.
ras> multicast smcast set 23 239.255.255.255 7-9 fix
ras> multicast smcast show
vid group slot port(F:fix, X:forbid, -:normal)
---- --------------- ---- ------------------------------------------------
1 224.0.0.0 1 2 3 4
123456789012345678901234567890123456789012345678
1 XXXX
2 XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
3 XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
4 XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
5 ------------------------------------------------
Press any key to continue, 'e' to exit
ras>
To Next Page
Loading...
