ZyXEL Communications MSC1000G - Page 763

Chapter 29 port Commands
Management Switch Card User’s Guide
763
set <slot-port-vpi/vci>
<profile> <mux>
<pvid> <priority>
[acname <acname>]
[srvcname <srvcname>]
[hellotime
<hellotime>]
Configures a PVC for PAE translation.
acname: The host name of the access concentrator.
srvcname: A descriptive name for the service that
uses this PVC.
hellotime: The timeout (0~600 seconds) for the
PPPoE session.
Note: Make sure the VID is not already used for
MVLAN or TLS PVC.
8
show <slot>|<slot-
port>|<slot-port-
vpi/vci>
Displays the PAE PVC settings for the specified port
and/or slot.
1
pots cid set <slot-port> <AS-type>
<payload-type>
Applies to the MSC1024GC. Sets the AS type and
payload type of CID (Caller Identification).
AS-type: the AS type of CID, 0~5
0: DEFVAL (use the setting of country code)
1: CID during ring
2: DTAS CID before ring
3: RPAS CID before ring
4: LR DTAS CID before ring
5: LR CID before ring
<payload-type>: the payload type of CID, 0~8
0: DEFVAL (use the setting of country code)
1: MDMF
2: SDMF
3: ETSI MDMF
4: ETSI SDMF
5: DTMF
6: UK MDMF
7: UK SDMF
8: Japanese MDMF
8
flash <slot-port>
DEFVAL|{<min> <max>}
Applies to the MSC1024GC. Set how long (in
milliseconds) a user has to press the flash key for
the IES to register its use.
DEFVAL : use the flash period defined in the
country code setting.
<min>: 20~1500 ms
<max>: 20~1500 ms, <max> >= <min>
8
gain <slot-port> <tx-gain>
<rx-gain> [datagain
<data-tx-gain> <data-
rx-gain>]
Sets the amount of gain (increase in volume) to
apply to the voice signal the subscriber transmits
(tx) or the signal the subscriber receives (rx). (-
200~200 in 0.1 dB). A negative value decreases
the volume.
You can also set the gain for data (fax or modem)
traffic.
8
Table 364 port Commands (continued)
COMMAND DESCRIPTION P