ZyXEL Communications MSC1000G - Page 764

Chapter 29 port Commands
Management Switch Card User’s Guide
764
impedance <slot-port>
<impedance>
Sets the impedance level on the specified
subscriber port.
impedance: 200ohm_680ohm_100nf,
220ohm_680ohm_100nf,
220ohm_820ohm_115nf,
220ohm_820ohm_120nf,
270ohm_750ohm_150nf,
300ohm_1000ohm_220nf,
370ohm_620ohm_310nf, 600ohm,
600ohm_1000nf, 900ohm, 900ohm_2160nf
and DEFVAL
Note: DEFVAL impedance is set at the impedance
of the country defined in the countrycode
command.
loop <slot-port> 2600|3200
Applies to the MSC1024GC. Set the maximum loop
resistance in ohms.
2600: maximum loop resistance in ohms.
3200: maximum loop resistance in ohms.
ppvc delete <slot-port-vpi/vci>
Removes a priority-based PVC. 8
member delete <slot-port-
vpi/vci> <vpi/vci>
Removes a PVC channel from PPVC group. 8
set <slot-port-vpi/
vci> <vpi/vci>
<atmprofile>
<priority>
Adds a priority-PVC into the group.
atmprofile: Specify the ATM profile using
profile atm commands.
8
set <slot-port-vpi/vci>
<mux> <pvid>
<priority>
Creates a priority-based PVC. 8
show <slot>|<slot-
port>|<slot-port-
vpi/vci> [detail]
Displays runtime configured virtual channels. 1
vlan <slot-port-vpi/vci>
<vid> <registration>
<tag>
Adds a PPVC channel to a VLAN. 8
pvc delete <slot-port-vpi/vci>
Removes a PVC (Permanent Virtual Circuit). 8
mvlan disable <slot-port-
vpi/vci>
Deactivates multicast VLAN on the PVC. 8
enable <slot-port-
vpi/vci>
Activates the multicast VLAN in the PVC. 8
pvlan delete <slot-port-
vpi/vci> <etype>
Deletes a protocol VLAN setting on a specified DSL
port.
8
set <slot-port-vpi/
vci> <etype> <vid>
<priority>
Deletes a protocol VLAN on a specified DSL port. 8
Table 364 port Commands (continued)
COMMAND DESCRIPTION P