ZyXEL Communications MSC1000G - Page 765

Chapter 29 port Commands
Management Switch Card User’s Guide
765
set <slot-port-vpi/vci>
<profile> <mux>
<pvid> <priority>
[acname <acname>]
[srvcname <srvcname>]
[hellotime
<hellotime>]
Creates or modifies a PVC setting.
profile: The asynchronous transfer mode (ATM)
profile. Specify the ATM profile using profile atm
commands.
acname: The hostname of a remote access concen-
trator. You can use 1-31 printable ASCII charac-
ters. Spaces are allowed.
srvcname: The name of the service that uses this
PVC. You can use 1-31 printable ASCII characters.
Spaces are allowed.
hellotime: The timeout (0~600 in seconds) for
the PPPoE session. Enter 0 if there is no timeout.
Note: Use these acname, srvcname, and hellotime
settings for the ALC1372G-51 only.
8
show <slot>|<slot-
port>|<slot-port-
vpi/vci> [detail]
Displays runtime configured virtual channels. 1
usratelimit enable <slot-port-
vpi/vci>
Activates upstream rate limiting on the specified
PVC.
8
disable <slot-port-
vpi/vci>
Deactivates upstream rate limiting on the specified
PVC.
8
set <slot-port-vpi/
vci> <rate>
Sets the maximum upstream rate (in Kbps) the
specified PVC is allowed to use.
8
show <slot>|<slot-
port>|<slot-port-
vpi/vci>
Displays upstream rate limiting settings for the
specified slots, ports, or PVCs.
1
vlan <slot-port-vpi/vci>
<vid> <registration>
<tag>
Adds a PVC channel to a VLAN. 8
xvlan delete <slot-port-
vpi/vci> <cvid>
Removes the specified XVLAN entry (cvid) from the
specified PVC channel.
8
set <slot-port-vpi/
vci> <cvid> <svid>
Creates an XVLAN entry for the specified PVC
channel. cvid is the original customer VLAN ID.
When the port receives traffic from the subscriber
with a cvid VLAN tag, XVLAN changes it to the
svid before forwarding it to the service provider’s
network.
8
show <slot-port-vpi/vci>
Displays the XVLAN settings for the specified PVC
channel.
1
shdsl alarmprof <slot-port>
span|stuc|stur|*
<alarmprofile>
Sets SHDSL ports or end point(s) to use an alarm
profile.
span: set alarm profile for the whole span
stuc: set alarm profile at stuc end point
stur: set alarm profile at stur end point
*: set alarm profile at both stuc and stur
8
Table 364 port Commands (continued)
COMMAND DESCRIPTION P