ZyXEL Communications MSC1000G - Page 767

Chapter 29 port Commands
Management Switch Card User’s Guide
767
password <slot-port>
<password>
Specifies the SIP password a port on a VoIP line
card uses.
8
polarityrever
se
<slot-port> <on|off>
Use this command to turn polarity reversal on or
off. Turn on polarity reversal to reverse the tip and
ring after a call is established and again after it
terminates.
8
set <slot-port> <sip-
profile> <svc-
profile> [<dsp-
profile> [data
<data_profile>]]
Sets a port on a VoIP line card to use the specified
SIP, SVC and DSP profiles.
sip-profile: SIP or dial plan profile name (<=31
characters).
svc-profile: Call service profile name (<=31
characters).
dsp-profile: DSP profile name (<=31
characters).
data-profile: The DSP profile name of data
mode (<=31 characters).
8
tax <slot-port> <type>
Sets the type of polarity reversal signal that should be
sent.
type: disable, 12k, 16k, reversal_12k, reversal_16k,
reversal_steady, reversal_pulse
8
tel <slot-port>
<telephone-
no>
Records a port(s) subscriber’s telephone number. 8
tlspvc delete <slot-port-vpi/vci>
Removes a TLS (Transparent LAN Service) on the
PVC.
8
set <slot-port-vpi/vci>
<profile> llc|vcmux
<vid> <priority>
Sets/changes TLS PVC settings. 8
show <slot>|<slot-
port>|<slot-port-
vpi/vci>
Displays the settings for a TLS PVC. 1
vdsl alarmprof <slot-port> <profile>
Sets the VDSL port(s) to use the specified alarm
profile.
8
compatible <slot-port>
none|adsl2|adsl2+
Configures ADSL spectrum compatibility for VDSL2
ports.
8
dpbo disable <slot-port>
Disables Downstream Power Back Off (DPBO) on
the specified port.
8
enable <slot-port>
Enables DPBO on the specified port. 8
Table 364 port Commands (continued)
COMMAND DESCRIPTION P