ZyXEL Communications MSC1000G - Port Ipbpvc Edgerouter Show Command

Chapter 29 port Commands
Management Switch Card User’s Guide
801
29.20.3 port ipbpvc edgerouter show Command
Syntax:
port ipbpvc edgerouter show <all | domain-name [<vid>]>
where
This command displays the edge routers for the specified VLAN or for all VLAN.
An example is shown next.
The output values correspond to the input values of other IP bridge edge router commands.
29.21 IP Bridge Interface Commands
Use these commands to set up and maintain forwarding information for downstream traffic.
Downlink interfaces provide forwarding information for downstream traffic. The system learns some
of this information by snooping DHCP packets. For static IP addresses, you should provide this
information manually. In this case, specify the VLAN ID and, optionally, the PVC for a range of IP
addresses. The system uses the VLAN ID to identify the domain the downlink interface is in.
Downlink interfaces in the same domain cannot have overlapping IP addresses.
29.21.1 port ipbpvc interface delete Command
Syntax:
port ipbpvc interface delete <ip/mask> <vid>
where
This command deletes the specified downlink interface. You can only remove downlink interfaces
that were added manually.
<domain name>=
The name of the domain.
<vid>=
The ID (<1..4094>) of the VLAN.
ras> port ipbpvc edgerouter show all
domain ip/mask vid
------------------------------- ------------------ --------
ISP1 123.23.19.249/24 102
ISP1 123.23.19.254/24 101
example 192.168.1.200/24 402
<ip/mask>=
Downlink interface’s IP address, in dotted decimal notation and number of bits
<1..32> in the subnet mask.
<vid>=
The ID (<1..4094>) of the VLAN.