ZyXEL Communications MSC1000G - Port Pvc Xvlan Show Command

Chapter 29 port Commands
Management Switch Card User’s Guide
818
29.29.13 port pvc xvlan show Command
Syntax:
port pvc xvlan show <slot-port-vpi/vci>
where
This command displays the XVLAN settings for the specified PVC channel.
29.30 port shdsl Commands
Use the port shdsl commands to configure the subscriber SHDSL ports.
29.30.1 port shdsl alarmprof Command
Syntax:
port shdsl alarmprof <slot-port> span|stuc|stur|* <alarmprofile>
where
This command sets the specified SHDSL port(s) or end point(s) to use an alarm profile.
The following example sets SHDSL port 8 on the line card in slot 6 to use the SESalarm alarm
profile at both the STU-C and the STU-R.
29.30.2 port shdsl mode Command
Syntax:
port shdsl mode <slot-port> atm|efm
<slot-port-
vpi/vci>
=
The slot and port(s) and VPI/VCI of the PVC.
span|stuc|stur|*
=
span: Sets the alarm profile for the whole span. This is the entire connection
including any SHDSL regenerators that might be located between the STU-C
(SHDSL Termination Unit - Central) and STU-R (SHDSL Termination Unit -
Remote) end points. An SHDSL regenerator amplifies the SHDSL signal in
order to increase the connection distance.
stuc: Sets the alarm profile at STU-C (SHDSL Termination Unit - Central)
end point
stur: Sets the alarm profile at STU-R (SHDSL Termination Unit - Remote)
end point
*: Sets alarm profile at both STU-C and STU-R
<alarmprofile>
=
The name of an SHDSL alarm profile.
ras> port shdsl alarmprof 6-8 * SESalarm