ZyXEL Communications MSC1000G - Port Sip Opmode Command

Chapter 29 port Commands
Management Switch Card User’s Guide
822
The following example sets port 1 in card 4 to use “sip-example” SIP user account.
29.34 port sip opmode Command
Syntax:
port sip opmode <slot-port> <DEFVAL|v5sip>
where
This command sets the operation mode of a VoIP port.
The following example sets card 3’s port 5 to use V5.2.
29.35 port sip hotline Command
Syntax:
port sip hotline <slot-port> off|[on <hotline-no> <timeout>]
where
This command turns on or off the hotline of a port on a VoIP line card. You can set the hotline number and its
timeout value if it is turned on.
29.36 port sip password Command
Syntax:
port sip password <slot-port> <password>
ras> port sip account 4-1 sip-example
DEFVAL
=
Configures the port to use SIP to connect to a server.
v5sip
=
Configures the port to use V5.2 to connect to a traditional class 5 POTS switch.
ras> port sip opmode 3-5 v5sip
<hotline-no>
=
Sets the the hotline of a port on a VoIP line card. <=31 characters, only
alphanumeric characters and '+' are allowed or use two quotation marks () to
clear the field.
Note: '+' is only allowed at the first character.
<timeout>
=
Sets the hotline timeout, 0~255 seconds, 0 means dial immediately.