Chapter 29 port Commands
Management Switch Card User’s Guide
824
29.39 port tel Command
Syntax:
port tel <slot-port> <telephone-no>
where
This command records a subscriber’s telephone number for the specified port(s). On the VOP line
card, each port’s telephone number is a SIP URI identity (SIP phone number) and must be unique.
The following example records a telephone number of 123456789 for port 5 on the line card in slot
3.
29.40 Transparent LAN Service (TLS)
Transparent LAN Service (also known as VLAN stacking or Q-in-Q) allows a service provider to
distinguish multiple customers VLANs, even those with the same (customer-assigned) VLAN ID,
within its network. Refer to Section 9.2.12 on page 209 for more information.
Use the
port tlspvc commands to configure VLAN stacking settings for the specified PVC(s).
Note: You can NOT configure PPPoA-to-PPPoE and TLS settings on the same PVC.
29.40.1 port tlspvc delete Command
Syntax:
port tlspvc delete <slot-port-vpi/vci>
This command clears TLS settings for the PVC.
29.40.2 port tlspvc set Command
Syntax:
port tlspvc set <slot-port-vpi/vci> <profile> llc|vcmux <vid> <priority>
where
<telephone-no>
=
The subscriber’s telephone number.
ras> port tel 3-5 123456789
<profile>
=
Name of an ATM profile.
llc|vcmux
=
Encapsulation method (llc or vcmux).
To Next Page
Loading...
