Chapter 29 port Commands
Management Switch Card User’s Guide
831
where
This command sets the PSD mask for the option bit on the specified port.
The following example sets the PSD mask to “VDSL2_A_NUS0” on traffic on port 5 on the VDSL
card in slot 4.
29.41.11 port vdsl limitmask show Command
Syntax:
port vdsl limitmask show <limit_mask>
<limitmask> =
The PSD (Power Spectrum Density) mask.
limitmask:
1: VDSL2_A_NUS0
2~11: VDSL2_A_EU[32,36,40,44,48,52,56,60,64,128]
12: VDSL1_FTTEX_ANSI_M1
13: VDSL1_FTTEX_ANSI_M2
14: VDSL1_FTTCAB_ANSI_M1
15: VDSL1_FTTCAB_ANSI_M2
16: VDSL1_FTTEX_ANSI_M1_e
17: VDSL1_FTTEX_ANSI_M2_e
18: VDSL1_FTTCAB_ANSI_M1_e
19: VDSL1_FTTCAB_ANSI_M2_e
20: VDSL2_A_CT
21~36: VDSL2_B8_[1..16]
37~46: VDSL2_B7_[1..10]
47: VDSL2_BT_ANFP
48: VDSL2_C_138_b
49: VDSL2_C_276_b
50: VDSL2_C_138_co
51: VDSL2_C_276_co
Four additional customer-defined PSD shapes can be configured per system.
ras> port vdsl limitmask set 4-5 1
To Next Page
Loading...
