Chapter 30 profile Commands
Management Switch Card User’s Guide
849
set <profile> vcshaping <level>
<max-rate> <depth>
Sets the VC (Virtual Circuits) shaping level,
maximum rate, and depth of a IPQoS2
profile.
level: The associated PVC level.
max-rate: The maximum rate of the
queue.
depth: The maximum number of packets.
8
queue <profile> <id>
<weight>|<max-rate> <depth>
Sets the parameters of a queue for a
specified IPQoS2 profile.
id: The queue index beginning at 0. For
example, if you have configured 4 queues
for a profile, then you can enter a id from 0
to 3.
weight: The queue’s queue weight.
max-rate: The maximum rate of the
queue.
depth: The maximum number of packets.
8
show [profile]
Displays all configured IPQoS2 profiles or a
specified profile.
1
profsvr show
Displays the current profile server setting. 1
mode client|server
Sets the profile server operation mode. 8
clientlis
t
set <ip-address> <type>
Adds an entry to the profile server client list. 8
delete <ip-address>
Removes an entry from the profile server
client list.
8
show
Displays the profile server client list. 1
serverset <ip-address>
Sets the target profile server IP address for
synchronization.
8
sync
Synchronizes with the profile server. 8
qratelimi
t
delete <profile>
Removes the specified per-queue rate limit
profile.
8
map <profile>
Displays the port(s) to which the specified
per-queue rate limit profile is applied.
1
set <profile>
[q0|q1|q2|q3|q4|q5|q6|q7
<cir> <pir>]
Configures the specified per-queue rate limit
profile.
cir: per-queue CIR in kbps, 0 means no
limit, 0~100032 in steps of 64 kbps.
pir: per-queue PIR in kbps, 0 means no
limit, 0~100032 in steps of 64 kbps.
8
Displays the specified per-queue rate limit
profile’s settings.
1
ratelimit delete <profile>
Removes the specified Ethernet subscriber
port rate limit profile.
8
map <profile>
Displays the Ethernet subscriber port(s) to
which the specified rate limit profile is
applied.
8
Table 366 profile Commands (continued)
COMMAND DESCRIPTION P
To Next Page
Loading...
