ZyXEL Communications MSC1000G - Page 850

Chapter 30 profile Commands
Management Switch Card User’s Guide
850
set <profile> <ingress-rate>
<egress-rate>
Configures an Ethernet subscriber line
ingress and egress rate profile.
8
show [<profile>]
Displays the name(s) of the rate limit
profile(s) you have configured. Specify a
profile to see it’s details.
1
shdsl delete <profile>
Removes an unreferenced SHDSL port
settings profile.
8
map <profile>
Displays which SHDSL ports reference this
profile.
1
set <profile> <min-rate> <max-
rate> [<annex> <wire_pair>
<pms> [margin]]
Creates a profile of SHDSL port settings.
min-rate: The minimum rate (192~4096
Kbps).
max-rate
: The maximum rate (192~4096
in Kbps).
annex
: Region setting: annexa|
annexb
.
wire-pair
: The number of wire pairs to be
used. Choose 2wire|4wire|mpair4.
pmms: Line probing. Options are:
lp_off: Disables the line probe.
lp_on_cur: Enables the line probe based
on the current target SNR margin.
lp_on_wc: Enables the line probe based
on the worst case target snr margin.
curr-margin
: The current condition target
SNR margin (-10~21 dB).
margin: The current noise margin or worst
case noise margin (-10~21 dB).
8
show [<profile>]
Lists the SHDSL port setting profiles or a
specific profile’s settings.
1
vdsl delete <profile>
Removes a VDSL port settings profile. 8
map <profile>
Displays which VDSL ports reference this
profile.
1
Table 366 profile Commands (continued)
COMMAND DESCRIPTION P