Chapter 30 profile Commands
Management Switch Card User’s Guide
884
30.13.4 profile ipqos2 set Command
Syntax:
profile ipqos2 set <profile> vcshaping <level> <max-rate> <depth>
where
This
command sets the VC (Virtual Circuits) shaping level, maximum rate, and depth of a IPQoS2
profile.
30.13.5 profile ipqos queue Command
Syntax:
profile ipqos2 queue <profile> <id> <weight>|<max-rate> <depth>
where
This
command sets the parameters of a queue for a specified IPQoS2 profile.
30.13.6 profile ipqos2 show Command
Syntax:
profile ipqos show <profile>
Displays all configured IPQoS2 profiles or a specified profile.
30.14 profile profsvr Commands
Use these commands to configure the profile server feature settings.
profile An IPQoS2 profile name.
level The assoiciated PVC level.
max-rate The maximum rate of the queue.
depth The maximum number of packets.
profile An IPQoS2 profile name.
id 0~the number of queues-1. The queue index beginning at 0. For example, if you
have configured 4 queues for a profile, then you can enter a id from 0 to 3.
weight You can configure different IPQoS2 profiles with queues that have the same queue
priority level. IPQoS2 then uses Weighted Round Robin (WRR) scheduling to service
these queues on a rotating basis based on their queue 2weight. Use these fields to
set the priority weight (1~127) of each queue in an IPQoS profile. The higher a
queue’s weight, the more service it gets.
max-rate The maximum rate of the queue.
depth The maximum number of packets.
To Next Page
Loading...
