Chapter 30 profile Commands
Management Switch Card User’s Guide
886
This command removes an entry from the profile server client list.
The following example removes a profile server client entry for an IES at IP address 1.2.3.4.
30.14.5 profile profsvr clientlist show Command
Syntax:
profile profsvr clientlist show <ip-address>
This command displays the profile server client list.
30.14.6 profile profsvr serverset Command
Syntax:
profile profsvr serverset <ip-address>
This command sets the target profile server IP address for synchronization. When the IES is in
client mode, use this command to specify the IP address of the IES in server mode.
The following example sets an IP address of 5.6.7.8 to use in synchronizing profile settings.
30.14.7 profile profsvr sync Command
Syntax:
profile profsvr sync
This command has the IES synchronize it’s profile settings. If the IES is in client mode, it will
attempt to get profile settings from the IES in server mode. If the IES is in server mode, it will send
its profile settings to the IES’s in the profile server client list.
30.15 profile ratelimit Commands
Use these commands to configure Ethernet subscriber line ingress and egress rate profiles
ras> profile profsvr clientlist delete 1.2.3.4
ras> profile profsvr clientlist show
no Client Ip type
---- --------------- ------
01 1.2.3.4 0
02 1.2.3.5 0
ras> profile profsvr serverset 5.6.7.8
To Next Page
Loading...
