ZyXEL Communications MSC1000G - Profile Voip H248 Show Command

Chapter 30 profile Commands
Management Switch Card User’s Guide
905
This command sets up an h248 profile. An example is shown to set up an h248 profile
(h248_profile), an MGC IP address (123.3.3.3), MGC port (1025), no secondary MGC, protocol
(udp), long encoding, a pbit of 1, a DHCP bit of 1, and T.38 fax relay support on.
30.20.4 profile voip h248 show Command
Syntax:
profile voip h248 show <profile>
This command displays the specified h248 profile. An example is shown to displays all h248
profiles.
30.21 profile voip sip Commands
Use these commands to set up and manage SIP profiles. SIP profiles map to ports on the VoIP line
cards, and contain the SIP server connection details.
30.21.1 profile voip sip delete Command
Syntax:
profile voip sip delete <name>
This command removes the specified SIP profile. An example is shown to delete the SIP profile
named “bar”.
30.21.2 profile voip sip map Command
Syntax:
profile voip sip map <name>
forcever
off|on
=
You can set this to on if the MGC only supports H.248 version 2.
Set it to off to use H.248 version 2.
ras> profile voip h248 set h248_profile 123.3.3.3 mgcport 1025 mgc2 off
transport udp encode long pbit 1 dscp 1 t38 on
ras> profile voip h248 show
H.248 profile(s):
----------------------
1. DEFVAL
2. h248_profile
ras> profile voip sip delete bar