Chapter 32 show Commands
Management Switch Card User’s Guide
933
32.3 show Commands
Use these commands to display runtime status information.
inm <slot-port>
curr|15min|
1day
Displays the VDSL2 port’s impulse noise monitoring
statistics.
1
line <slot-port>
Displays the status of the VDSL2 line connected to
the specified port.
1
medleypsd <slot-port>
Displays the final PSD the system proposes to the
connected CPE during line initialization for the
VDSL2 line connected to the specified port.
1
qln <slot-port>
Displays the QLN (Quiet Line Noise) parameter for
the VDSL2 line (connected to the specified port).
This is to see the line’s noise level.
The Quiet Line Noise for a DMT tone is the rms (root
mean square) level of the noise present on the line,
when no ADSL signals are present. It is measured in
dBm/Hz. The QLN can be used in analyzing
crosstalk.
1
snr <slot-port>
Displays the SNR (Signal to Noise Ratio) parameter
for the VDSL2 line (connected to the specified port).
This is to see the line’s signal strength.
1
vlan [<vid>]|[
<start-vid> <end-
vid>]
Displays current VLANs. 1
voip h248 interface
<id>
Displays the status of the specified H.248 interface. 1
media <id>
<media>
Displays the status of the specified H.248 media
card.
1
termination
info
*|<id>-
<media>-
<port> |
<id> <name>
Displays H.248 termination names. 1
termination
state
Displays H.248 termination states. 1
rtp <slot-port>
Displays RTP traffic statistics on a port. 1
sip serverstate
<slot>
[<proxysvr-
ip> |
<proxysvr-
dn>]
Displays the status of SIP proxy server while the
"local call" feature is enabled.
proxysvr-ip: The IP address of the SIP proxy
server.
proxysvr-dn: The domain address of the SIP proxy
server.
1
Table 368 show Commands (continued)
COMMAND DESCRIPTION P
To Next Page
Loading...
