Chapter 32 show Commands
Management Switch Card User’s Guide
940
The following table describes labels in this example.
32.3.4 show cfm Command
Syntax:
show cfm mep
This command displays all CFM maintenance end point information.
The following is an example.
32.3.5 show dot3ad Command
Syntax:
show dot3ad [<slot>]
This command displays the (IEEE 802.3ad) link aggregation settings.
Table 373 show atm Command Display
LABEL DESCRIPTION
rx cells This field shows the number of ATM cells received on this port.
tx cells This field shows the number of ATM cells transmitted on this port.
rx rate This field shows the number of kilobytes per second received on this port.
tx rate This field shows the number of kilobytes per second transmitted on this port.
crc errors This field shows the number of Cyclic Redundancy Check errors on this port.
since pvc
create
This column displays the ATM traffic statistics that have accumulated from when the PVC
was created (either via command or the building of the DSL link).
since last
reset
This column displays the ATM traffic statistics that have accumulated from the most
recent time that the counters were reset.
ras> show cfm mep
maintenance domain : MD_0
maintenance association : L2SW-DSLAM
MEP id status mac state LastFailedOkUpTime
------ ------- ----------------- ----------------- ------------------
1 local 00:13:49:98:23:4c connection active
To Next Page
Loading...
