ZyXEL Communications MSC1000G - Show Ip Command

Chapter 32 show Commands
Management Switch Card User’s Guide
953
32.3.14 show ip Command
Syntax:
show ip
This command displays the management IP settings and statistics. An example is shown next.
32.3.15 show ip6 default-router Command
Syntax:
show ip6 default-router
This command displays the IPv6 addresses of on-link routers that will help forward packets. See
Section 12.16.5 on page 480 for more details.
ras> show ip
outband[enif0] inband[swif0]
-------------- --------------- ---------------
inet : 192.168.0.1 123.23.19.206
netmask : 255.255.255.0 255.255.255.0
broadcast : 192.168.0.255 123.23.19.255
mtu : 1500 1500
vid : - 1
in octet : 0 11201874
in unicast : 0 26230
in multicast : 0 3676
in discard : 0 749
in error : 0 0
in unknown : 0 749
out octet : 0 265141
out unicast : 0 1646
out multicast : 0 0
out discard : 0 0
out error : 0 0
ras>
ras> show ip6 default-router
Interface: In-band
Address preference lifetime expire flag
--------------------------------------- ---------- --------- --------- ------
Interface: Out-of-band
Address preference lifetime expire flag
--------------------------------------- ---------- --------- --------- ------