ZyXEL Communications MSC1000G - Page 984

Chapter 33 switch Commands
Management Switch Card User’s Guide
984
show
Displays the bandwidth control settings. 1
bcastctrl show
Displays broadcast and multicast storm control
settings.
1
threshold <giga-port> <bc-
limit> <mc-limit>
<uu-limit>
Sets the limitations of broadcast, multicast and
unknown unicast packets, in packets per second
for each trunk port (0~262143, -1 means no
limit).
bc-limit
: broadcast packet limit
mc-limit
: multicast packet limit
uu-limit
: unknown unicast packet limit
8
cfm disable
Disables Connectivity Fault Management (CFM). 8
enable
Enables CFM. 8
lbr disable <giga-
port>|<slot-port>
Disables loopback testing on the specified port on
a line card.
8
enable <giga-
port>|<slot-port>
Enables loopback testing on the specified port on
a line card.
8
show
Displays loopback testing settings. 1
ma delete <md-name>
<ma-name>
Deletes a maintenance association (MA). 8
meplist delete
<md-name> <ma-
name> <ep-id>
Deletes a list of MA end points (MEP). 8
meplist set <md-
name> <ma-name>
<mep-id>
Sets a list of MEP. 8
set <md-name> <ma-
name> <primary-
vlan> [<cci-
interval>]
Set an MA.
primary-vlan: primary served VLAN of this
association.
cci-interval: continuity check message
initiation interval, range is 4~7.
4: 1 s
5: 10 s
6: 1 min
7: 10 min
8
vlan delete <md-
name> <ma-name>
<vlan-id>
Deletes a VLAN from an MA. 8
vlan set <md-name>
<ma-name> <vlan-
id>
Associates a VLAN with an MA. 8
md delete <md-name>
Deletes an MD. 8
set <md-name>
<level>
Sets an MD and it’s level.
level: maintenance domain level, 0~7
8
Table 386 switch Commands (continued)
COMMAND DESCRIPTION P