Chapter 33 switch Commands
Management Switch Card User’s Guide
985
mep delete <md-name>
<ma-name> <mep-id>
Deletes a MEP. 8
set <md-name> <ma-
name> <mep-id>
<giga-
port>|<slot-port>
<direction>
<priority> [cci
<cci-enabled>]
[alm <alarm-time>]
[rst <reset-
time>] [mac <mac>]
Sets an endpoint in the association.
direction: Choose up|down. This is the active
SAP direction, up means CFM PDUs are sent
towards relay entity and then forwarded to other
bridge ports, down means CFM PDUs are sent out
the bridge port to network
priority: the priority carried in those CFM PDUs
sent out from this endpoint
cci-enabled: indicate whether to issue CCM or
not, default 0
0: disabled
1: enabled
alarm-time: The time before an alarm is issued,
default 2.5 s, range is 2.5~10 s.
reset-time: The time before an alarm state is
reset, default 10 s, range is 2.5~10 s.
Note: Before using this command, you must add
the MEP ID in the legal MEP list of the MA
using switch cfm ma meplist set
command.
8
mip delete <md-name>
<ma-name> <giga-
port>|<slot-port>
Deletes a maintenance association intermediate
point (MIP).
8
set <md-name> <ma-
name> <giga-
port>|<sid> <mac>
Sets a MIP. 8
mlbm respond
disable
Set MIPs to respond to mLBM messages (not
compatible with link state Ethernet protocol).
8
mlbm respond
enable
Set MIPs to not respond to mLBM messages. 8
mode 1|2
Sets CFM to use IEEE 802.1ag (1) or the ITU-T
Recommendation Y.1731 (2) which also deals with
performance management.
8
show [<md-name> <ma-
name>
Displays MDs, a detailed MD or a detailed MA
configuration.
1
dot3ad aggport <portlist>
t1|t2|t3|t4|none
Creates a link aggregation trunk groups. 8
disable [t1|t2|t3|t4]
Turns off link aggregation on the specified trunk
group.
8
enable [t1|t2|t3|t4]
[lacp]
Turns on link aggregation on the specified trunk
group.
lacp turns on LACP protocol.
8
lacp priority
<priority>
Sets the LACP system priority (0~65535). 8
show
Displays LACP settings. 1
Table 386 switch Commands (continued)
COMMAND DESCRIPTION P
To Next Page
Loading...
