ZyXEL Communications MSC1000G - Page 986

Chapter 33 switch Commands
Management Switch Card User’s Guide
986
timeout short|long
Sets the time interval between exchanging LACP
packets.
8
show
Displays the link aggregation state. 1
dscp show
Displays DSCP-IEEE 802.1p mappings on this
device.
1
disable
Deactivates DSCP-IEEE 802.1p mappings on this
device.
8
enable
Activates DSCP-IEEE 802.1p mappings on this
device.
8
set <srccp> <mapcp>
<mappri>
Sets DSCP-IEEE 802.1p mappings on this device.
srccp
: source code point (0~63), for example:
1,3~5,10~15.
mapcp: code point, 0~63
mappri: priority, 0~7
8
garptimer join <join-msec>
Sets the GARP timer’s Join Timer (100~32766
milliseconds).
8
leave <leave-msec>
Sets the GARP timer’s Leave Timer in (201~65534
milliseconds).
8
leaveall <leaveall-msec>
Sets the GARP timer’s Leave All Timer in
(202~65535 milliseconds)
8
set <join-msec>
<leave-msec>
<leaveall-msec>
Sets GARP timers. 8
show
Displays the GARP timer settings. 1
isolation disable
Turns off the subscriber isolation feature. 8
enable
Turns on the subscriber isolation feature. 8
vlan delete <vid>
Deletes the specified isolation VLAN. 8
set <vid>
Creates the specified isolation VLAN. 8
show
Displays the subscriber isolation feature’s current
setting.
1
lldp enable
Have the MSC use LLDP to send and get
information about devices connected to its
interfaces.
8
disable
Turns off LLDP. 8
txinterval <sec>
Sets the advertised interval (in seconds) the MSC
waits before sending LLDP frames.
8
txhold <cycles>
Sets the time-to-live (TTL) multiplier of the LLDP
frames.
8
reinitdelay <sec>
Sets a minimum number of seconds for LLDP to
wait to re-initialize a port that was disabled.
8
txdelay <sec>
Set the delay (in seconds) between the successive
LLDP frame transmissions initiated by value or
status changes in the local system.
8
notifyinter
val
<sec>
Sets the interval (in seconds) between sending
notifications due to changes in information about
adjacent devices.
8
Table 386 switch Commands (continued)
COMMAND DESCRIPTION P