ZyXEL Communications MSC1000G - Page 987

Chapter 33 switch Commands
Management Switch Card User’s Guide
987
show
Displays the LLDP settings. 8
port adminstatus <port>
disable|tx|rx|tx-
rx
Sets how the MSC uses LLDP on this port.
disable: has the MSC not send or receive LLDP
information through this port.
tx: only send local LLDP information through this
port.
rx: only receive remote LLDP information through
this port.
tx-rx: send local LLDP information and receive
remote LLDP information through this port.
8
flush <port>
Removes all the LLDP entries from the port’s
table.
8
local <port>
Displays the port’s LLDP settings. 8
notify <port>
enable|disable
Enables or disables the sending of notifications
about changes in the adjacent devices through
this port.
8
remote <port>
[<index>]
Display details about the specified remote device
connected to the specified port.
8
set <port> <tlv>
Specifies the information the port sends.
0x0001 : port description
0x0002 : system name
0x0004 : system description
0x0008 : system capabilities
0x0010 : management address
0x0100 : port VLAN ID
0x0400 : VLAN Name
0x1000 : dot3 mac/phy configuration
0x4000 : dot3 link aggregation
0x8000 : dot3 maximum frame size
8
mac aging set <aging-time>
Sets the MAC aging out time period.
aging-time: 0, 10~10000 in seconds or
disable
8
show
Displays the MAC aging out time period. 8
flush enet|all
Clears the MAC table on the Ethernet ports or all
ports (Ethernet and subscriber ports).
8
mirror enable
Activates port mirroring to copy an MSC uplink
port’s traffic flow to a monitor port.
8
disable
Turns off port mirroring. 8
monitorport <port>
Specifies the port to which to copy the mirrored
port.
port: a gigabit Ethernet port, enetx where
x=1~6
8
Table 386 switch Commands (continued)
COMMAND DESCRIPTION P