ZyXEL Communications MSC1000G - Page 989

Chapter 33 switch Commands
Management Switch Card User’s Guide
989
enable <giga-port>
Turns on data transmission on a port. 8
flowctrl disable <giga-
port>
Turns off flow control on a port. 8
enable <giga-port>
Turns on flow control on a port. 8
frametype <giga-port>
all|tag
Sets the port(s) to accept VLAN tagged and
untagged Ethernet frames or only tagged.
8
gvrp disable <giga-
port>
Turns on GVRP for a port(s). 8
enable <giga-port>
Turns off GVRP for a port(s). 8
mode <giga-port>
uplink|subtend
Sets a port to operate as uplink or subtending. 8
mstp disable <giga-
port> <mstid>
Deactivates MSTP on the port in the spanning tree
instance.
8
enable <giga-port>
<mstid>
Activates MSTP on the port in the spanning tree
instance.
8
pathcost <giga-
port> <mstid>
<pathcost>
Sets the path cost (0~200 000 000). Enter 0 to
have the system automatically set the path cost
based on the link speed.
8
p2plink <giga-
port>
auto|enable|disab
le
Enables point-to-point connection. 8
priority <giga-
port> <mstid>
<priority>
Specify the priority (0~255) of the Ethernet port
in the MST region. The system automatically
rounds the number to the nearest multiple of 16.
8
show <mstid>
[<end_mstid>]
Displays MSTP settings. 1
name <giga-port> <name>
Sets the name of a port.
giga-port: enetx (x=1~6) or all if trunk is
disabled, t1|t2|all if trunk is enabled.
name: length <=47 characters, space is not
allowed.
8
priority <giga-port>
<priority>
Sets a port’s default ingress user priority (0~7). 8
pvid <giga-port> <vid>
Sets the PVID (Port VLAN ID) (1~4094) assigned
to untagged frames or priority frames (0 VID)
received on this port(s).
8
show
Displays port settings. 1
speed <giga-port>
<speed>
Sets a port’s speed and duplex mode. 8
vlantrunk disable <giga-
port>
Turns off VLAN trunking on a port to have it only
accept frames with registered VIDs.
8
enable <giga-port>
Turns on VLAN trunking on a port to have it accept
frames with any VID.
8
Table 386 switch Commands (continued)
COMMAND DESCRIPTION P