Chapter 33 switch Commands
Management Switch Card User’s Guide
995
This command displays loopback testing settings. The following shows an example.
33.5.3.6 switch cfm ma delete
Syntax:
switch cfm ma delete <md-name> <ma-name>
where
This command deletes the specified maintenance association.
33.5.3.7 switch cfm ma meplist delete
Syntax:
switch cfm ma meplist delete <md-name> <ma-name> <mep-id>
where
This command deletes a list of maintenance association end points. The following example deletes
the end point identifier “2” from the list of end point identifiers for the maintenance association
“ma1” in the maintenance domain “md1”.
33.5.3.8 switch cfm ma meplist set
Syntax:
switch cfm enable <md-name> <ma-name> <mep-id>
ras> switch cfm lbr show
Giga port
---------
sub1: disable
sub2: disable
up1: disable
up2: disable
DSL port
--------
6-1: enable
6-2: disable
6-3: enable
<md-name> =
The maintenance domain.
<ma-name> =
The maintenance association.
<mep-id> =
The end point identifier.
ras> switch cfm meplist delete md1 ma1 2
To Next Page
Loading...
