Chapter 11 Network Address Translation (NAT)
NBG4604 User’s Guide
124
Note: You must create a firewall rule in addition to setting up NAT, to allow traffic from
the WAN to be forwarded through the NBG4604.
11.2 What You Can Do
•Use the General screen (Section 11.3 on page 124) to enable NAT and set a
default server.
•Use the Application screen (Section 11.4 on page 125) to change your
NBG4604’s port forwarding settings.
•Use the Advanced screen (Section 11.5 on page 128) to change your
NBG4604’s trigger port settings.
11.3 General NAT Screen
Use this screen to enable NAT and set a default server. Click Network > NAT to
open the General screen.
Figure 71 Network > NAT > General
The following table describes the labels in this screen.
Table 46 Network > NAT > General
LABEL DESCRIPTION
NAT Setup
Enable Network
Address
Translation
Network Address Translation (NAT) allows the translation of an Internet
protocol address used within one network (for example a private IP
address used in a local network) to a different IP address known within
another network (for example a public IP address used on the Internet).
Select the check box to enable NAT.
Default Server Setup
To Next Page
Loading...
