Chapter 17 Remote Management
NBG4604 User’s Guide
163
and configuration file maintenance for details. To use this feature, your computer
must have an FTP client.
Use this screen to specify which interfaces allow FTP access and from which IP
address the access can come. To change your NBG4604’s FTP settings, click
Management > Remote MGMT > FTP. The screen appears as shown.
Figure 91 Management > Remote Management > FTP
The following table describes the labels in this screen.
17.7 The SNMP Screen
Simple Network Management Protocol is a protocol used for exchanging
management information between network devices. Your NBG4604 supports
SNMP agent functionality, which allows a manager station to manage and monitor
the NBG4604 through the network. The NBG4604 supports SNMP version one
Table 63 Management > Remote Management > FTP
LABEL DESCRIPTION
Server Port You may change the server port number for a service, if needed.
However, you must use the same port number in order to use that
service for remote management.
Server Access Select the interface(s) through which a computer may access the
NBG4604 using this service.
Secured Client
IP Address
A secured client is a “trusted” computer that is allowed to communicate
with the NBG4604 using this service.
Select All to allow any computer to access the NBG4604 using this
service.
Choose Selected to just allow the computer with the IP address that
you specify to access the NBG4604 using this service.
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to begin configuring this screen afresh.
To Next Page
Loading...
