ZyXEL Communications NBG4604 - Page 57

Chapter 5 AP Mode
NBG4604 User’s Guide
57
The following table describes the labels shown in the Status screen.
Table 19 Status Screen (AP Mode)
LABEL DESCRIPTION
Device Information
System Name This is the System Name you enter in the Maintenance > System >
General screen. It is for identification purposes.
Firmware Version This is the firmware version and the date created.
LAN Information
- MAC Address This shows the LAN Ethernet adapter MAC Address of your device.
- IP Address This shows the LAN port’s IP address.
- IP Subnet Mask This shows the LAN port’s subnet mask.
- DHCP This shows the LAN port’s DHCP role - Client.
WLAN Information
- MAC Address This shows the wireless adapter MAC Address of your device.
- Status This shows the current status of the Wireless LAN - On or Off.
- Channel This shows the channel number which you select manually.
- Operating Channel This shows the channel number which the NBG4604 is currently using
over the wireless LAN.
- 802.11 Mode This shows the IEEE 802.11 standard that the NBG4604 supports.
Wireless clients must support the same standard in order to be able to
connect to the NBG4604
- SSID This shows a descriptive name used to identify the NBG4604 in the
wireless LAN.
- WPS This shows the WPS (WiFi Protected Setup) Status. Click the status to
display Network > Wireless LAN > WPS screen.
System Status
System Up Time This is the total time the NBG4604 has been on.
Current Date/Time This field displays your NBG4604’s present date and time.
System Resource
- CPU Usage This displays what percentage of the NBG4604’s processing ability is
currently used. When this percentage is close to 100%, the NBG4604 is
running at full load, and the throughput is not going to improve anymore.
If you want some applications to have more throughput, you should turn
off other applications.
- Memory Usage This shows what percentage of the heap memory the NBG4604 is using.
Interface Status
Interface This displays the NBG4604 port types. The port types are: LAN and
WLAN.
Status For the LAN port, this field displays Down (line is down) or Up (line is up
or connected).
For the WLAN, it displays Up when the WLAN is enabled or Down when
the WLAN is disabled.