ZyXEL Communications NBG4604 - Enable and Configure Wireless Security Without WPS on Your NBG4604

Chapter 6 Tutorials
NBG4604 User’s Guide
67
6.2.2 Enable and Configure Wireless Security without WPS
on your NBG4604
This example shows you how to configure wireless security settings with the
following parameters on your NBG4604.
Follow the steps below to configure the wireless settings on your NBG4604.
The instructions require that your hardware is connected (see the Quick Start
Guide) and you are logged into the Web Configurator through your LAN connection
(see Section 3.3 on page 28).
1 Open the Wireless LAN > General screen in the NBG4604’s Web Configurator.
2 Make sure the Enable Wireless LAN check box is selected.
3 Enter SSID_Example3 as the SSID and select a channel.
4 Set security mode to WPA-PSK and enter ThisismyWPA-PSKpre-sharedkey in
the Pre-Shared Key field. Click Apply.
Figure 32 Tutorial: Network > Wireless LAN > General
SSID SSID_Example3
Channel 6
Security WPA-PSK
(Pre-Shared Key: ThisismyWPA-PSKpre-sharedkey)