ZyXEL Communications P-661HNU - Configuring the Wireless Client Using the Zyxel Utility; Connecting to a Wireless Lan

Chapter 3 Tutorials
P-661HNU-Fx User’s Guide
42
3 Enter “SSID_Example3” as the SSID and select Auto in the Channel Selection
field to have the device search for an available channel.
4 Select 802.11b/g in the Mode Select field.
5 Select More Secure as your security level and set security mode to WPA-PSK
and enter “ThisismyWPA-PSKpre-sharedkey” in the Pre-Shared Key field. Click
Apply.
6 Click Connection Status > System Info.Verify your wireless and wireless
security settings under Device Information and check if the WLAN connection is
up under Interface Status.
Tutorial: Network > Wireless LAN > SecuritOpen the Status screen. Verify your wirele ss and wireless security settings unde r Device Information and check if the WLAN connection is up under Interface Status
Tutorial: Status
This finishes the configuration of the AP.
3.3.3 Configuring the Wireless Client using the ZyXEL Utility
This section describes how to connect the wireless client to a network using a
ZyXEL USB Wireless adapter and the ZyXEL utility. Follow these steps only if you
are using this utility.
3.3.3.1 Connecting to a Wireless LAN
There are three ways to connect the client to an access point.
• Configure nothing and leave the wireless client to automatically scan for and
connect to any available network that has no wireless security configured.
• Manually connect to a network.
• Configure a profile to have the wireless client automatically connect to a specific
network or peer computer.