ZyXEL Communications PK5000Z - Advanced Internet Connection Setup

PK5000Z Quick Start Guide
4
1 Select Active and click Next to continue. It is strongly recommended that Enable OTIST is NOT selected.
See section 7 for more information.
2 Configure your wireless settings in the screen. Click Next .
3) If you select either WEP or WPA-PSK security (recommended), then follow the directions to enter
the appropriate key. Click Next to continue and Apply to save your wireless LAN settings.
4 Check your configuration and write down your wireless LAN settings for later use. Click Finish to complete and
save the wizard setup.
5 Your Internet is ready for you to use. Open your browser and navigate to your favorite website.
4 Internet Connection Setup Using Advanced Settings
Use this section to set up your Internet connection manually if you do not see the ISP Parameters for Internet
Access screen when you run the wizard (see section 4, step 4).
1 Login again. (Follow steps 1 to 5 in section 3.)
2 Select Go to Advanced setup. Then, click Apply .
3 The Status screen appears. Click Network > WAN in the navigation panel on the left of the screen.
4 Enter the information exactly as provided by your ISP. Click Apply .
5 If you still cannot access the Internet, see Troubleshooting and/or contact your Internet Service Provider
(ISP) for assistance.