1/2 Copyright © 2018 Zyxel Communications Corp. All Rights Reserved
2
3
2
3
1
LAN
POWER
4
PON
Connect the power cable and press
the power button.
Make sure the LEDs are on and
check the status.
Connect a computer using an
Ethernet cable.
Connect the fiber optic cable to
the PON port.
Warning! To avoid possible eye
injury, do NOT look into an
operating fiber-optic module's
connector.
Quick Start Guide
1
INTERNET
Red
Green
Green
Off
Off
Off
Off
(Loss of Signal)
On: Power on and system ready
Off: Power off
On: Successful GPON fiber link
Blinking: Synching with OLT (fiber terminal)
Off: Power off
On: Not receiving an optical signal
Blinking: Receiving a weak optical signal
Off: Receiving a normal optical signal
Blinking: Transmitting/Receiving data on the
Ethernet link
Green
On: Successful Ethernet link
Off: Ethernet link down
PMG1005-T20B
GPON SFU with 1-port GbE LAN
Hardware Connections
POWER
PON
LOS
LAN
To Next Page
Need help?
General
