Chapter 16 System
PMG5318-B20A User’s Guide
139
16.3 Time Setting
To change your GPON Device’s time and date, click Maintenance > System > Time Setting. The
screen appears as shown. Use this screen to configure the GPON Device’s time based on your local
time zone.
Figure 73 System > Time Setting
The following table describes the fields in this screen.
Table 54 System > Time Setting
LABEL DESCRIPTION
Current Time
Current Time This field displays the time of your GPON Device.
Each time you reload this page, the GPON Device synchronizes the time with the time
server.
Current Date This field displays the date of your GPON Device.
Each time you reload this page, the GPON Device synchronizes the date with the time
server.
Time and Date
Setup
Get from Time
Server
Select this radio button to have the GPON Device get the time and date from the time
server you specified below.
Time Protocol Indicates that the GPON Device uses the NTP format, which displays a 4-byte integer
giving the total number of seconds since 1970/1/1 at 0:0:0.
Time Server
Address
Enter the IP address or URL (up to 20 extended ASCII characters in length) of your time
server. Check with the ISP/network administrator if you are unsure of this information.
Apply Click Apply to save your changes back to the GPON Device.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
