ZyXEL Communications PMG5318-B20A - Page 28

Chapter 4 WAN
PMG5318-B20A User’s Guide
28
The following table describes the labels in this screen.
Table 5 Internet Access Setup - PPPoE
LABEL DESCRIPTION
General
WAN interface type Select PPPoE as the method of encapsulation used by your ISP from the drop-down
list box.
WAN IP Connection Select IPv4 to have this WAN run IPv4 only.
Select IPv6/IPv4 to allow this WAN to run IPv4 and IPv6 at the same time.
Select IPv6 to have this WAN run IPv6 only.
User Name Enter the user name exactly as assigned by the ISP. If assigned a name in the form
user@domain where domain identifies a service name, then enter both components
exactly as given.
Password Enter the password associated with the user name above.
Service Name Type the name of your PPPoE service here.
Authentication
Method
The GPON Device supports PAP (Password Authentication Protocol) and CHAP
(Challenge Handshake Authentication Protocol). CHAP is more secure than PAP;
however, PAP is readily available on more platforms.
Use the drop-down list box to select an authentication protocol for outgoing calls.
Options are:
AUTO - Your GPON Device accepts either CHAP or PAP when requested by this remote
node.
CHAP - Your GPON Device accepts CHAP only.
PAP - Your GPON Device accepts PAP only.
Service
Service Description Enter a description to identify this WAN interface.