Chapter 4 WAN
PMG5318-B20A User’s Guide
33
The following table describes the labels in this screen.
Table 6 Internet Access Setup - IP
LABEL DESCRIPTION
General
WAN interface type Select IP as the method of encapsulation used by your ISP from the drop-down list
box.
WAN IP Connection Select IPv4 to have this WAN run IPv4 only.
Select IPv6/IPv4 to allow this WAN to run IPv4 and IPv6 at the same time.
Select IPv6 to have this WAN run IPv6 only.
ARP Ping
Enable ARP Ping Select this to have the GPON Device send ARP requests to the gateway regularly if the
gateway IP might change often. If the GPON Device does not receive the gateway’s
response, the GPON Device requests a new gateway IP through DHCP.
Service
Service Description Enter a description to identify this WAN interface.
802.1Q VLAN ID This shows the VLAN ID assigned to traffic for this connection. Click Edit to open a
screen where you can select a different VLAN ID. See Section 4.3.4 on page 37 for
information on this screen.
802.1P Priority
Method
Select the 802.1P priority method to be assigned to traffic sent through this
connection.
To Next Page
Loading...
