Chapter 14 Interface Grouping
VMG1312-Bx0D User’s Guide
181
Figure 101 Interface Group Configuration
The following table describes the fields in this screen.
Table 74 Interface Group Configuration
LABEL DESCRIPTION
Group Name Enter a name to identify this group. You can enter up to 30 characters. You can use letters,
numbers, hyphens (-) and underscores (_). Spaces are not allowed.
WAN Interface
used in the
grouping
Select the WAN interface this group uses. The group can have up to one PTM interface, up to
one ATM interface, up to one ETH interface, and up to one WWAN interface.
Available LAN
Interfaces
Select one or more LAN interfaces (Ethernet LAN, HPNA or wireless LAN) in the Available
LAN Interfaces list on the right side and use the left arrow to move them to the Available
LAN Interfaces list on the left side to add the interfaces to this group.
To remove a LAN or wireless LAN interface from the Available LAN Interfaces on the left
side, use the right-facing arrow.
Automatically
Add Clients
With the
following DHCP
Vendor IDs
Click Add to identify LAN hosts to add to the interface group by criteria such as the type of
the hardware or firmware. See Section 14.2.2 on page 182 for more information.
# This shows the index number of the rule.
To Next Page
Loading...
