ZyXEL Communications XGS-4528F - Configure Rapid Spanning Tree Protocol; Figure 52 Advanced Application > Spanning Tree Protocol > RSTP; Table 27 Advanced Application > Spanning Tree Protocol > RSTP

Chapter 11 Spanning Tree Protocol
XGS-4528F User’s Guide
114
11.4 Configure Rapid Spanning Tree Protocol
Use this screen to configure RSTP settings, see Section 11.1 on page 107 for more information
on RSTP. Click RSTP in the Advanced Application > Spanning Tree Protocol screen.
Figure 52 Advanced Application > Spanning Tree Protocol > RSTP
The following table describes the labels in this screen.
Table 27 Advanced Application > Spanning Tree Protocol > RSTP
LABEL DESCRIPTION
Status Click Status to display the RSTP Status screen (see Figure 53 on page 116).
Active Select this check box to activate RSTP. Clear this checkbox to disable RSTP.
Note: You must also activate Rapid Spanning Tree in the
Advanced Application > Spanning Tree Protocol >
Configuration screen to enable RSTP on the Switch.